Emerson Exchange 365

Entering charge weight set points into faceplate

HI,

I have been asked if it is possible for the operator to have to enter the same figure into the faceplate for charge weight set points twice before it is accepted. 

From a safety point of view this would reduce the amount of errors but I'm not sure this is possible?

any help is greatly appreciated.

Thank you in advance.

Lee Wren

• faceplate enter charge weight safety

Lee W.

• 2 Mar 2015 8:26 AM
• Cancel

4 Replies

• Greg Schirm

  

  • 2 Mar 2015 12:44 PM

  Hi Lee - just a quick point of clarification - is your faceplate question about Ovation or DeltaV?

  • Cancel
• Lee W.

  

  • 2 Mar 2015 6:26 PM

  In reply to Greg Schirm:

  Hi Greg, DeltaV, I seem to have managed to put this in the wrong place, apologies.

  • Cancel
• Rachelle McWright

  

  • 2 Mar 2015 6:28 PM

  In reply to Greg Schirm:

  No worries @lee , thanks for the clarification Greg Schirm. I will move this to the correct group. :)

  Best Regards,

  Rachelle McWright: Business Development Manager, Dynamic Simulation: U.S. Gulf Coast

  • Cancel
• Lee W.

  

  • 2 Mar 2015 6:33 PM

  In reply to Rachelle McWright:

  I already have Rachelle, thankyou

  • Cancel