Emerson Exchange 365

• Not Answered

In need of some advice for Motor permissive to run & stop.

Need some advice to where to start on for a motor permissive to stop after a sequence is complete?

gbilly

• 6 Mar 2024 5:59 PM
• Cancel

3 Replies

• KeithStThomas

  

  • 6 Mar 2024 6:10 PM

  The question is a little lacking in detail. Are you looking for what to program into a SFC to turn a motor off? You could just write to the DC1/SP parameter directly, set it to stop. A permissive will prevent a motor from starting, but will not stop a motor that is already running. Did you mean an interlock? While an interlock will stop the motor, you cannot start the motor again until the interlock is cleared. Depending how the module is configured, an interlock of a running motor will trigger an alarm too.
  
  Some more information about what you are looking for and/or trying to achieve would help us help you.

  • Cancel
• gbilly

  

  • 6 Mar 2024 6:29 PM

  Thank you for the quick response, I apologize I am completely new to the delta v program. As I believe it’s function block setup, I got a fan motor blower on a heater that needs to be turned off after heater is started. But it remains running after start sequence is complete on every startup.

    

  • Cancel
• gbilly

  

  • 6 Mar 2024 6:29 PM

  In reply to KeithStThomas:

  Thank you for the quick response, I apologize I am completely new to the delta v program. As I believe it’s function block setup, I got a fan motor blower on a heater that needs to be turned off after heater is started. But it remains running after start sequence is complete on every startup.

  • Cancel