Recent Control & Safety Systems Discussions
Similar Posts
Batch Banner (one/single phase)
Batch Executive - Bad Phases when Disabled?
Batch - resetting EM parameters from phase
Help configuring a new phase
Change Data Type of Phase class Batch Parameter after its been created
Share

Adding a new Batch Phase

I created a new batch phase class.  A phase using the class was added to 4 units on the same controller so therefore its difficult to complete download.  We have since discovered that the phases were disabled (because it was new??) downloaded the 4 units.

Now recipe procedures that use the new phase will not load because the phase is disabled.   Can the new phases be enabled without having to download the unit?

Jane Kiekhaefer
  • Jane Kiekhaefer

    In reply to Matt Stoner:

    Thanks for the response, Matt. We got it to work after several trials/failures so am not sure if order of certain actions was involved. The main oversight was forgetting to update BS "download unit equipment". However doing that and downloading the phase, the unit download flag is not clearing which did not appear until the enable was set on the phase. Downloading the unit solves the issue.

This is the official online community site of the Emerson Global Users Exchange, a forum for the free exchange of non-proprietary information among the global user community of all Emerson Automation Solution's products and services. Our goal is to improve the efficiency and use of automation systems and solutions employed at members’ facilities by sharing our knowledge, experiences, and application information.

User Groups | World Areas | Community Guidelines | Legal Information | Privacy Policy | Contact Community Manager

Website translation provided by Website Translator

© 2015-2022 Emerson Global Users Exchange. All rights reserved.