Recent Services Discussions
Similar Posts
Referencing in Phase using alias or phase parameter ?
DeltaV Interface to PCS7 for a phased migration
Optimizing Multiphase Reactors with a Single Phase Product
Achieving Tight Control of Single Phase Liquid Reactors
PID Control in 3-Phase Oil and Gas Separation
Share

No unit phases or Phase logic modules error during OP verification

Hello Experts,

I was following a painting tutorial and created an operation called OP_FINISH. However, when I assigned it to the Batch Executive and attempted verification, it resulted in an error message.

I understand that the assigned unit class has phases that include the phase logic, as I have tested these phases during the phase testing section of the tutorial.

Any assistance would be appreciated.

Thank you in advance.

Nirit
  • Matt Stoner
    All Unit Instances that would be assigned would need the AGITATE and DRAIN phases marked as controller. Also make sure that the unit instances are under Process Cells that are linked to a Process Cell Class and the area that the unit instances are assigned is assigned to the batch executive.

This is the official online community site of the Emerson Global Users Exchange, a forum for the free exchange of non-proprietary information among the global user community of all Emerson Automation Solution's products and services. Our goal is to improve the efficiency and use of automation systems and solutions employed at members’ facilities by sharing our knowledge, experiences, and application information.

User Groups | World Areas | Community Guidelines | Legal Information | Privacy Policy | Contact Community Manager

Website translation provided by Website Translator

© 2015-2022 Emerson Global Users Exchange. All rights reserved.