• Not Answered

Need to Enable access to Full Manual Command in FP for Quench PID when we are not in operator mode and with certain condition in the Logic.

Hi ALL,

Hope everyone is doing  good...

In my project, I have a requirement from customer to have a some condition clubbed to the Current User <> Operator & when compressor is in RUN mode in Logic to Enable the access the full manual mode in FP for Quench PID

As of now I am using the DVSYS.THISUSER/USERNAME.A_CV in the VB code to write the current login user to the module and use that to trigger this condition. But sometimes if I go above operator level which we can do without closing the DeltaV operate or the FP, the acesss level is nor getting updated as the code runs when we reopen the FP.

Is there any solution for this or any roundabout for this ??

Thanks for spending time and replying....

have a great day..

Senthilkrishnan