Emerson Exchange 365

• Not Answered

magnetic level indcator and transmitter

Hello

what is minimum distance (gap) between float chamber and galvanic vessel or steel structure?

Regards

Mohsenv

MOH

• 10 Nov 2016 2:05 AM
• Cancel

6 Replies

• Gerard van Boven

  

  • 10 Nov 2016 7:28 AM

  I would say enough distance to install and tighten the bolts/nuts of the flanges in between the chamber and the vessel...

  • Cancel
• MOH

  

  • 10 Nov 2016 9:55 AM

  In reply to Gerard van Boven:

  Hi Mr. Boven
  Thanks for your answer. is there any refernce document for minimum distance?
  Regards
  Mohsenv

  • Cancel
• Gerard van Boven

  

  • 10 Nov 2016 11:38 AM

  In reply to MOH:

  no reference document for minimum distance.
  general guidelines for installation of level measurement in bypasses and stilling wells can be found here± www2.emersonprocess.com/.../00840-0300-4024.pdf

  • Cancel
• lisawoo

  

  • 10 Nov 2016 1:25 PM

  In reply to Gerard van Boven:

  Hello, There is not a reference for the distance within the manual but the clamps that are with the MLI will set the distance needed.

  • Cancel
• lisawoo

  

  • 10 Nov 2016 1:28 PM

  In reply to lisawoo:

  The distance would be approximately 1/2 inch or less with the clamp.

  • Cancel
• MOH

  

  • 11 Nov 2016 2:32 AM

  In reply to lisawoo:

  Hello
  Thanks Mr. Lisawoo and Mr. Boven

  • Cancel