Emerson Exchange 365

• Not Answered

Ramp Down of Ramp Function Block

Hi,

I am using Ramp function for ramp up it is behaving perfectly it goes from 40 to 100 as end value slowly. How do I use or change in the ramp function to use it as a ramp down, do I need to change the end value from 100 to 0. So that It starts from 40 and goes to 0 slowly.

Regards,

Arslan Latif.

Arslan Latif

• 26 Sep 2018 2:42 AM
• Cancel

1 Reply

• kmarks

  

  • 26 Sep 2018 3:12 PM

  Hello Arslan,
  
  The RAMP function block will ramp the output in whichever direction is required to achieve the end value. You are correct that to ramp from the input start value (in your example 40) down to 0, you simply need to set the end value to 0. There are no other configuration changes that need to be made. Hope this helps!

  • Cancel