Control module and Faceplate MERROR

Faceplate showing me the error because it was configure with AI module.I remove that module and now I have DI module rather than AI.How I can change it in faceplate?

• Block_ERR

OZ123

• 2 Sep 2015 1:18 PM
• Cancel

2 Replies

• Nikki Bishop

  

  • 2 Sep 2015 1:57 PM

  Hi OZ123. If you are trying to create a DI faceplate to go with a DI module, you can go to the module in DeltaV Explorer and change the faceplate mapping to a DI faceplate in the properties dialog box. (Right click on the DI module in DeltaV Explorer and then choose Properties). If I have misunderstood your request, reply here and I can help further.

  Nikki Bishop, PE |  Director, Global Turnaround Program [email protected]

  • Cancel
• OZ123

  

  • 3 Sep 2015 7:47 AM

  In reply to Nikki Bishop:

  Hi!
  I have faceplate which is actually Analog valve faceplate and MERROR is looking for AI module if AI module is ok then MERROR is ok.But I just remove the AI and add DI signals to convert it into Digital valve but faceplate still looking for AI module.How I can change AI module reference to DI.so MERROR will gone.

  • Cancel