Hi everyone,
I have been experiencing 4 active alarm everyday when allowing Danalyzer 370XA GC to perform Automatic Calibration after 24 Hours. But when I untick auto Calibration and perform manual calibration the alarm does not appear for the case of Calibration and on Validation side alarm still appears even though when I perform Manual Validation.
The alarms are Stream 5 Validation Failure
Please let us share the experience on resolving these alarms permanently on auto calibration and validation mode.
Billy
In reply to John Hay:
In reply to Billy Hok:
In reply to Jim McLelland:
In reply to jamie marsden: